Application Networking

I have implemented WCCP redirect on a serial interface I have. I also have a GRE tunnel interface sourced from that same serial interface.I would like to know the IOS order of operation for that GRE tunnel interface in regards to redirection. Do I ha...

Hi,I urgently need some help/advice on this issue, I have 2 ACE units (4710's) for our development environment, one with 0.5GB licence and the other one has the default 1GB licence (which is not applied). We need to connect these in a redundant manne...

Hi all,i hope i can find some help here within the forums. we ran into the following issue during a migration from foundry to the ACE-20 loadbalancers:ACE: with normal TCP probing on (example) port 7525 the ACE opens the socket, waits for the 3 way h...

Hi guys.I would like to know if I can migrate the config from ACE20 to ACE30 (last software) without any issue.I don't have any ACE30 to test Thanks a lot!

I have a pair of ACE 4710's that I am deploying within a datacenter.  The primary and secondary ACE appliances have identical configurations except for the IP addressing and priorities for FT.  The FT peer is going into a TL error state.  On the prim...

I'm having trouble with the functionality of backup servers in a serverfarm.Lets say I have three rservers in a serverfarm. Each rserver has a backup-server assigned to it. When a probe detects that one of the three nodes failed, the ACE puts the bac...

Hi, I am using WaaS for a long time now. With the new appnav module on the waas box, i am little confused about how to deploy. I have two WAN router connected to two firewalls in HA through L2 switches. I have two WaaS boxes in-line between the L2 sw...

Instructions on the upgrade page says:Instructions on how to apply the firmware update are posted on cisco.com together with the firmware in the file named L4_15427_FIRMWARE.pdf, which you can see after you click the Download link for the firmware.Ho...

I have one sticky group for multiple vservers and within each vserver is a different serverfarm with the same IPs but each server farm has a different probe.  Now if you look in the sticky table there will  be only once entry if my sticky is by sourc...

Hello,I'm new on ACE technologies , I would like to know how to configure a redirection on the ACE from HTTP to HTTPS using specific URLexample http://test.domain.com to https://test.domain.com, the SSL certificates were installed on the servers.Than...

Hi all , One of my WAVE-274 has this alarm :CMS status is offline.It appears offline on the central manager GUI but it is reachable by Telnet . This is the message I get when logging :System Initialization Finished.Disk based software not installed.S...

We have to use no normalization, no icmp-guard on ACE 5(2.0) to allow a One-Arm config to allow asymmetric traffic, i.e. everything of some rservers needs to go through the alias ip.Now this works but the connection table fills up pretty quickly and ...