still facing some problem and need someone help me find out where the problems are:
please see the attached diagram: 2 syslog servers have DG to 10.122.70.15, which is the VIP in CSS, CSS use layer 3 approach, and configure default route point to 10.122.70.1 which is router. two CSSs are running ASR redundancy:
CSS1:
!*************************** GLOBAL ***************************
flow-state flow-disable timeout 10
flow-state 514 udp flow-disable nat-enable
ip route 0.0.0.0 0.0.0.0 10.122.70.1 1
ip route 10.122.56.0 255.255.255.0 10.122.25.1 1
!************************* INTERFACE *************************
interface 1/1
trunk
vlan 25
vlan 70
interface 1/2
isc-port-one
interface 2/1
trunk
vlan 25
vlan 70
!************************** CIRCUIT **************************
circuit VLAN25
description "Management VLAN 25"
ip address 10.122.25.36 255.255.255.0
circuit VLAN70
ip address 10.122.70.30 255.255.255.0
ip virtual-router 1 priority 101
ip redundant-vip 1 10.122.70.15
!************************** SERVICE *************************
service Server13
ip address 10.122.70.13
port 514
protocol udp
redundant-index 1
active
service Server14
ip address 10.122.70.14
port 514
protocol udp
redundant-index 2
active
!*************************** OWNER ***************************
owner L3_Owner
content L3_Rule_syslog
redundant-index 3
add service Server13
add service Server14
vip address 10.122.70.15
protocol udp
port 514
balance srcip
active
CSS2:
!*************************** GLOBAL ***************************
flow-state flow-disable timeout 10
flow-state 514 udp flow-disable nat-enable
ip route 0.0.0.0 0.0.0.0 10.122.70.1 1
ip route 10.122.56.0 255.255.255.0 10.122.25.1 1
!************************* INTERFACE *************************
interface 1/1
trunk
vlan 25
vlan 70
interface 1/2
isc-port-one
interface 2/1
trunk
vlan 25
vlan 70
!************************** CIRCUIT **************************
circuit VLAN25
description "Management VLAN 25"
ip address 10.122.25.37 255.255.255.0
circuit VLAN70
ip address 10.122.70.31 255.255.255.0
ip virtual-router 1
ip redundant-vip 1 10.122.70.15
!************************** SERVICE *************************
service Server13
ip address 10.122.70.13
port 514
protocol udp
redundant-index 1
active
service Server14
ip address 10.122.70.14
port 514
protocol udp
redundant-index 2
active
!*************************** OWNER ***************************
owner L3_Owner
content L3_Rule_syslog
redundant-index 3
add service Server13
add service Server14
vip address 10.122.70.15
protocol udp
port 514
balance srcip
active
i have 2 client throw syslog traffic to 10.122.70.15, i but i can find only 1 server been logged into server13, cannot find the other client syslog in any of servers. can someone help me to find out where is the problem?
another question is: I should set the default gateway of server to VIP of CSS, right or not?
