CSS SSL Proxy - how can I write the original source address in http header

[bhooker]

I'm replacing some BigIP's with CSS11500's that are configured to do front/backend ssl proxying in a one-armed configuration. The BigIP's write the original source IP address as a http header value when the traffic is sent to the application, and the application uses the IP to match against an application ACL. How can I do the same in the CSS.

thanks,

Brian

[Gilles Dufour]

here is what you can insert with the SSL module :

http://www.cisco.com/en/US/products/hw/contnetw/ps792/products_configuration_guide_chapter09186a0080292a76.html#wp1027619

Gilles.

[bhooker]

so, unless I'm missing something, this cannot be done with the CSS?

[Gilles Dufour]

you're correct. This option does not exist on the CSS.

Gilles.