Application Networking

Hi all,On module CSM, real mail server is repeated either probe fail or operate about 5 minutes when I set Mail Server point to VIP. On the contrary if I set to Real server. But it's normaly before. And when I use my DNS server to ping, the Real serv...

Hi all,I couldn't find any command to check the GSS is making use of NTP to get the correct time from NTP server. Can anyone please advise how i can check. Thanks.Jianwen

Does WebNS license is different with ADI software license?I am kind of confused between these two softare on CSS11501. How to install WebNS "S11K-500ST-7.5" package into CSS11501.Many thanks,ttrinh

Hello,Does someone has a document that lists all the differences between the CSS, CSM and ACE. I don't really care about performances but more about features such as for example:RHI: not available on CSSBackup serverfarm: not available on CSSVirtual ...

Hi,I have CSS 11503 No-SSL V7.50I configured CSS for TACACS+ and altough I can see Tacacs+ Administration active (who is ran which command) log I cannot see TACACS Accounting active (who enter to CSS) log.here is the config:##########################...

I am trying to configure a CSM to use Load-Balancing Advisor on z/OS as a GWM.I have configured the CSM vlans as such: vlan 19 client ip address 176.11.16.11 255.255.240.0 gateway 176.11.16.235! vlan 9 server ip address 176.11.48.11 255.255.240.0The ...

Hi Gilles Could I have a CSS load balancing two servers and also have it communicate with a billing server across the network. If yes then how can I do it?Regards,Sushil

(FW)---(CSS11501)---(SERVERS)Basic configuration, everything on VLAN1. Servers in web farm are logging attacks, etc. Source IP address all show the CSS instead of the originating IP address coming from the outside.What do I need to add/change to allo...

We have 2 x 6509 with one CSM-S per switch. We have an Oracle mid-tiers/database setup and we are load-balancing to the mid-tiers. The CSM-S's are running in bridge mode. When we run an automated script against the mid-tiers to retrieve a standard we...

HiI need to configure CSS accept connections to VIP on 2 different TCP ports and forward them to the same tcp port on real servers.I cannot use secondary IP addresses on real servers.Planned configuration is service REALSERVER1 port 80 ip address 1.1...

Hello,have anyone a sample configuration for loadbalancing FTP through an ACE board? We have some problems with active FTP. RegardsAndr?

I have a problem with sticky table of csm.Our csm seemed not to be sticking a client to the servers correctly on sticky table info "sh mod csm x sticky" although the traffic from a client was exsited at that time.However, after the period of the time...