cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
492
Views
0
Helpful
1
Replies

CSS10500 Load Balancing Multiple Hosts

tkatsiaounis
Level 1
Level 1

Hello,

I have a CSS10500 switch and i would like to load balance the connections to a couple of hosts. My setup (roughly) is as follows


int e1-RTR1-------->int e2-Host1

                 -------->int e3-Host2

and

int e5-RTR2------>int e6-Host1

                 ------>int e7-Host2

How can i assing different interfaces to the two sets of hosts??? I want all ports (0-65535 and tcp/udp)  to go to both sets. I made a circuit vlan 1 and assigned it an ip address but i cannot make a circuit vlan 2 and when i assign multiple addresses to vlan1 i cannot somehow assign interfaces to each ip.

Is there anything i can do??

Sorry for all the fuss i am new to the CSS concept.

1 Accepted Solution

Accepted Solutions

Gilles Dufour
Cisco Employee
Cisco Employee

Let's start with the basic

http://www.cisco.com/en/US/products/hw/contnetw/ps792/products_configuration_example09186a008009438d.shtml

If you can't make it work, get back to us with whatever you have configured.

Verify that you can ping the CSS from the router and the server.

Gilles.

View solution in original post

1 Reply 1

Gilles Dufour
Cisco Employee
Cisco Employee

Let's start with the basic

http://www.cisco.com/en/US/products/hw/contnetw/ps792/products_configuration_example09186a008009438d.shtml

If you can't make it work, get back to us with whatever you have configured.

Verify that you can ping the CSS from the router and the server.

Gilles.