Hello @all!
On weekend we saw following error in our Cat6509 (12.2(33)SXI) for our ACE-Module A2(2.3)
switch#sh diagnostic events module 1
Diagnostic events (storage for 500 events, 500 events recorded)
Number of events matching above criteria = 8
Event Type (ET): I - Info, W - Warning, E - Error
Time Stamp ET [Card] Event Message
------------------ -- ------ --------------------------------------------------
08/15 02:35:04.367 E [1] diag_get_bus_swt_mode(): Error receiving SCP resp
onse forgetting the switching mode
08/15 02:35:09.375 E [1] diag_asic_read_reg16[1/1/42]: set_get_asic_regs()
failed (get)
08/15 02:35:09.383 E [1] queryHyperionSynched[1]: diag_asic_read_reg16 fai
led
08/15 02:35:09.387 E [1] test_asic_sync[1]: queryHyperionSynched failed
08/15 02:35:10.419 E [1] TestAsicSync Failed
08/15 02:35:10.431 E [1] diag_pf_const2_test_has_failed[1/-1]: reg_invoke_
diag_get_test_attribute_by_name failed
08/15 02:40:19.559 I [1] Diagnostics Passed
08/16 12:14:40.460 I [1] TestAsicSync Passed
You see, there is an error with the ASIC on the ACE-Module. Because of this the switch was shutting down interface Ten1/1 for about 20sec and made a reset of the module. First question is, if the failure is an hardware-issue?
Because of the reset, we had a failover with the redundant module in the other switch. In front of both we have a GSS which uses "KAL-AP by VIP". We use is for several VIPs and they are still working after the failover. Only for 2 VIPs, the ACE was sending a load of 0. In the config we found a fragment of an old configurations for "KAL-AP by Tag". Configuration looked like this
domain domain_KALAP-BUMS
add-object class-map cmap-vip_BUMS
Before you ask, the configuration on the GSS was "KAL-AP by VIP" and it was working fine before the failover. After the failover the new active module was sending a load of 0 to the GSS. Is this a bug? Did anyone had some similiar error?
Would be happy if someone can help us understanding.
Kind regards,
Marko
