08-22-2010 11:11 AM
Hi can you use the FWSM in both transparent and routed
mode when you have multiple contexts enabled? I.e. one context in routed mode and one in
transparent? Or is it simply one mode or the other no matter whether
single context or multi
context?
Thanks,
rays
Solved! Go to Solution.
08-22-2010 05:37 PM
Yes you can independently set each context's mode to either being routed or transparent in FWSM. Kindly go through the documentation at:
http://www.cisco.com/en/US/docs/security/fwsm/fwsm40/configuration/guide/fwmode_f.html
for additional information.
By the way as of now this is only available in FWSM as far as I know. ASA currently does not allow you to mix routed and transparent modes across different contexts.
Atif
08-22-2010 05:37 PM
Yes you can independently set each context's mode to either being routed or transparent in FWSM. Kindly go through the documentation at:
http://www.cisco.com/en/US/docs/security/fwsm/fwsm40/configuration/guide/fwmode_f.html
for additional information.
By the way as of now this is only available in FWSM as far as I know. ASA currently does not allow you to mix routed and transparent modes across different contexts.
Atif
08-23-2010 12:52 AM
Thaks a lot Atif. I obviously didn't go through the documentation thoroughly enough or I would have spotted that!.
Thanks,
rays
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide