Hi,
I have a configuration shown below:
---------------------------------------
owner HOMEDECK_CLUSTER
content HomeDeck_Cluster
add service HomeDeck_Cluster-9001-1
add service HomeDeck_Cluster-9001-2
add service HomeDeck_Cluster-9001-3
port 9001
protocol tcp
vip address 10.200.A.B
add service HomeDeck_Cluster-9002-1
add service HomeDeck_Cluster-9002-2
add service HomeDeck_Cluster-9002-3
advanced-balance sticky-srcip-dstport
sticky-inact-timeout 10
active
service HomeDeck_Cluster-9001-1
ip address 10.200.A.C
protocol tcp
port 9001
keepalive type tcp
keepalive port 9001
active
service HomeDeck_Cluster-9001-2
ip address 10.200.A.D
protocol tcp
port 9001
keepalive type tcp
keepalive port 9001
active
service HomeDeck_Cluster-9001-3
ip address 10.200.A.E
protocol tcp
port 9001
keepalive type tcp
keepalive port 9001
active
service HomeDeck_Cluster-9002-1
ip address 10.200.A.C
protocol tcp
port 9002
keepalive type tcp
keepalive port 9002
active
service HomeDeck_Cluster-9002-2
ip address 10.200.A.D
protocol tcp
port 9002
keepalive type tcp
keepalive port 9002
active
service HomeDeck_Cluster-9002-3
ip address 10.200.A.E
protocol tcp
port 9002
keepalive type tcp
keepalive port 9002
active
--------------------------
Buti there is a load balancing problem. When I look at the rule ststistics. I see an aoutput like this:
-------------------------------------
Name: Hits: Wgt: State: Ld: KAlive: Conn: DNS:
----- ----- ----- ------ --- ------- ----- ----
HomeDeck_Cluster-9001-1
1,494 S-1 Alive 88 TCP-9001 1 0
HomeDeck_Cluster-9001-2
1,797 S-1 Alive 2 TCP-9001 0 0
HomeDeck_Cluster-9001-3
141 S-1 Alive 2 TCP-9001 2 0
HomeDeck_Cluster-9002-1
1,359 S-1 Alive 2 TCP-9002 0 0
HomeDeck_Cluster-9002-2
298 S-1 Alive 43 TCP-9002 0 0
HomeDeck_Cluster-9002-3
80 S-1 Alive 2 TCP-9002 0 0
--------------------------------------
As you see, there is a load and hits problem.
How can set an homogeneous load and hits?
