customer want to implement a new ACI datacenter core layer to replace old catalyst 6509 core, many business running on old core, and it is required to run 7x24 ， and migrate is smooth and quiet.
we think we can connect a temp layer 2 trunk to aci border leaf , and create different tenant for different business, and direct traffic to appropriate VxLAN.
on leaf layer of ACI , we create vpc on two leaf 93 switch , and create hsrp group on leaf tenant l3out EPG, when migrate business from old network , if we want to migrate as smooth as possible ,we want to implement like these steps:
1.we can move standby hsrp address from old network to ACI HSRP,
2.hsrp active on old network form hsrp relation with hsrp standby on ACI
3.shutdown hsrp active layer3 interface . and hsrp standby interface on ACI become active hsrp, business server traffic‘s L3 gateway switch to ACI.
4、move hsrp active （before shutdown L3 interface on old network active hsrp) address to aci, and form hsrp relation ship
but I check hsrp on aci document, it doesn't support hsrp for VPC on ACI.
is this possible？
how can I migrate old business server from old Network to new ACI architecture as smooth as possible？
Cisco APIC supports HSRP version 1 by default. You can configure an interface to use HSRP version 2.
HSRP version 2 has the following enhancements to HSRP version 1:
Expands the group number range. HSRP version 1 supports group numbers from 0 to 255. HSRP version 2 supports group numbers from 0 to 4095.
For IPv4, uses the IPv4 multicast address 220.127.116.11 or the IPv6 multicast address FF02::66 to send hello packets instead of the multicast address of 18.104.22.168, which is used by HSRP version 1.
Uses the MAC address range from 0000.0C9F.F000 to 0000.0C9F.FFFF for IPv4 and 0005.73A0.0000 through 0005.73A0.0FFF for IPv6 addresses. HSRP version 1 uses the MAC address range 0000.0C07.AC00 to 0000.0C07.ACFF.
thank you we want to migrate an old data center network to new VxLAN network, customer don't permit to interrupt bussiness when migate, we want to use hsrp gateway switch over method to migrate gateway but customer want to use distrbute gateway , that is difficult to implement distribute gateway and hsrp under same interface vlan we haven't found a good method to transfer hsrp gateway to new distribute gateway and do not interrrupt bussiness thank you again
Good afternoon Friends, these days I was accessing the DNAC manager and my surprise is that I did not have access, after a basic analysis I observed that the equipment was operational, but without being able to access it via DNA GUI (browser) I also ident...
Today we are going to talk about how to configure backups in the Cisco ACI APIC Dashboard. As you might know APIC is a UCS based CIMC controller and we can check the configuration backups on the Cisco ACI APIC Dashboard. Remember that the HA solution must...
Listen: https://smarturl.it/CCRS9E14 Follow us: https://twitter.com/CiscoChampion
Organizations are undergoing digital transformation like never before. Global spending on digital transformation of business practices, products, and organization...
Recommended for customers on ACI releases 4.2(7r) and above or 5.2(3g) and above. Are you tired of manually gathering ACI logs and tech-support data?To this day, the process of gathering ACI logs and uploading them to your TAC case was cumbersome - y...