Line console access on CSS 11154
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-04-2004 09:07 AM
I received our two css's today and when i connect the console line i see no output.
On the starters guide they are mentioning a snap-on ferrite thingy.
That i did not get.
Does any body know a workaround to the problem.
Second question is what is the password recovery procedure on these machines.
Thanks in advance
- Labels:
-
Application Networking
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-07-2004 01:24 AM
The CSS uses a special console cable and connector.
Here is a document talking about this.
http://www.cisco.com/en/US/products/hw/contnetw/ps789/products_tech_note09186a00800a3f28.shtml
For the password recovery, check :
http://www.cisco.com/en/US/products/hw/contnetw/ps789/products_tech_note09186a00801746e6.shtml
Regards,
Gilles.
