Application Networking

Does the CSS support two Pix515 uplinks? I'm trying to setup a fully redundant path between my active/backup PIX and my active/backup CSS. I have one link to the pix that acts as a primary and a secondary link that is only active when the first lin...

In a 6509 running IOS 12.2(17a)SX3, I have WCCP configured and when I do 'show ip wccp' this is part of the output:Global WCCP information: Router information: Router Identifier: 164.72.232.129 Protocol Version: ...

Hello,I've recently aquired two CE550s w/ software 2.51. I've configured them and brought them online for transparent web caching with WCCPv2. What I discovered was that although my border router sees both of them only one of the CEs fills up. The se...

I would like to monitor whether my backup CSS is alive but for box-to-box redundancy, the backup CSS is always in cold standby and I am not able to ping to its management IP address. May I know how I achieve this?Thanks

I am trying to develop an ICAP service that will work with the CISCO 565 CEMy ICAP service requires authentication information to apply specific content changes based on the user and or group.It is my understanding from looking at the 565 documentati...

I received our two css's today and when i connect the console line i see no output.On the starters guide they are mentioning a snap-on ferrite thingy.That i did not get.Does any body know a workaround to the problem.Second question is what is the pas...

Hello,I have a problem running this configuration:PC (10.1.1.1) must connect to http service on 10.1.1.100CSS1 and 2 are performing balancing between FW1 and 2 (Nokia check point)CSS2 performs http balancing between SRV1 and 2 with VIP 192.168.2.100C...

This seems like a fairly stupid question however I have looked around I can't seem to find an exact answer.I have a CSS 15506 sitting in front an single test webserver and the IP addesses that are comming through the access log are just from the CCS'...

Is there a way of configuring the CSS to NAT the Back End Server IP Address, back to the VIP Address ?The reason I ask is that our CSS is accessed via a Checkpoint FW. The flow from my PC to the Load balanced server is fine and the retuun flow thru t...

I'm planning to put one CSS 11503 at siteA and another one at siteB. Both sites are connected with mutiple Gbps connections with low latency e.g. <0,5msec. Is there a distance limition for having the Adaptive session redundancy feature running betwee...

Hi,I am adding a new circuit, services etc to a master and standby CSS.Does it matter which order I install the circuits and make them redundant in relationship to the active one?I will add the following to each CSS.interface 2/6 phy 100Mbits-FD ...

now that the local director is eos. can anyone suggest what could i use that would serve the same purpose as the local director for the 2950 switch?