Problem with CSS11500, DNS and SSH.-

[Francisco Aguilar Aravena]

Dears:

I have a problem with the CSS11503. I need to balance DNS servers for the requests of these reach a vip you distribute the load.

I use these links:

http://www.cisco.com/en/US/products/hw/contnetw/ps789/products_configuration_example09186a00801d015a.shtml

https://supportforums.cisco.com/message/459776#459776

With these I manage to load balance DNS level but I can not manage computers via SSH, could someone tell me this may be due to

Thank you very much.

[Daniel Arrondo Ostiz]

Hi Francisco,

If you configured the content rule to match only DNS traffic, SSH will just get routed through the CSS and therefore, it should not be impacted.

Can you please copy your configuration here? I will have a look at it to see if there are any mistakes.

Alternatively, you can open a TAC service request to have this issue investigated further.

Regards

Daniel

[Francisco Aguilar Aravena]

My config is:

circuit VLAN23

  description "Red-DNS_Servers"

  ip address Y

!

service dns_pruebas

  ip address X

  keepalive type script ap-kal-dns "X"

  active

!

OWNER

content DNS_PRUEBA

    vip address X

    add service dns_pruebas

    active

!

group DNS

  vip address X

  add service dns_pruebas

  portmap disable

  active

Thanks for your help.

[Daniel Arrondo Ostiz]

Hi Francisco,

I meant your full configuration, not just parts of it and without masking any of the configuration lines.

If you are concerned about privacy, then, it would probably better if you open a TAC service request to have this investigated further.

Regards

Daniel