Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,I face an issue while creating source nat on cisco ACE. There is already a default source nat ip for the context. I created a new one for smtp traffic alone. Iam facing issues in prefixing the newly created nat-pool rule(nat-pool 100) above...
Hi there,I have a scenario where a group of servers need to connect a pair of application servers, but only one app server can be active and have connections at a time. I've setup a serverfarm with a single server as primary, then with a backup serv...
Hello EveryoneThis is my first post on the Support Community, so please allow me some room for not following etiquette. I have recently taken delivery of a replacement 4710 as one half of a pair. The unit that has been replaced was the primary in the...
Anyone have or seen a custom probe script for the Citrix XML or STA services for the ACE? Would like to do more than expect a status back, Citrix xml service can respond via HTTP but still have issues.Thanks!
Can someone tell me how to deploy Cisco WAAS Central Manager to manage 100 WAE devices over WAN? Is there any additional devices need to setup redundant design and any license cost included here per device basis to monitor? I need detailed solutio...
Dear all,we have the demand to do health checks using authentication for servers running SSL-encrypted services like imaps, smpts or pop3s. Has someone implemented tcl scripts for that ? Unfortunately the "SSL_PROBE_SCRIPT" provided by Cisco does onl...
Dear Expert,we would like to setup FTP server over CSS where our member sever use non-std-port to open both control/data channel (i.e. 6370 as ctrl and 6369 as data this case.) but seems we only get Passive mode FTP mode work only but not for Active ...
I am configuring a 3750 switch with 12.2(52)SE according to:(from https://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/release/12.2_52_se/configuration/guide/3750_scg.pdf )This example shows how to configure SVIs and how to enable the ...
Good afternoon!I've looked high and low, but can't make heads or tails of the WAAS (not WAAS Express) licensing on the SRE's. What do Small, Medium, Large denote in regards to how many users, connections, etc can each type of license handle? I can ...
Hi, We are using Cisco ACE 4710 for load balancing the servers. The predictor used is 'least connections'.Have observed the below;The number of connections for a particular server in a serverfarm is 15 in the Cisco ACE.The actual number of users in...
Hi,We have migrated CSM to ACE Module recentlym all the applications are working fine. But one of our real server , Hosting team did NIC Teaming (Active-Active) which was working fine but not with ACE Module (Briding Mode).My assumtion is because of ...
Hi,I have a pair of 4710's (ACE01 and ACE02) in fault tolerant config. I have followed standard config. guidelines. I have the following problem:(1) I reload ACE01 and ACE02 seems to take control.(2) After the reload completes, ACE01 does not accept ...
Hi guys,I know the CSS is too old but I have one in production environment and I was asked if it is possible to CSS to make NAT from inside addresses and translate them into one external IP address to diferent kind of communications, for example: 172...
Dear All,We have a CSS11506- in which the internal SSL-certificate is getting expired.Please revert on the steps for changing with a new certificate.Should i generate a new csr ? Thanks ,
