05-29-2014 01:14 PM
Dear Mister
Is possible to configure, shutdown a service using SNMP? More than this, in a context???
I am searching the OIDs about it, but, I am not lucky.
Regards and thank in advance
05-29-2014 02:11 PM
Hi,
I don't think so. You have list of MIB's available which can fetch data from ACE but there is no such provision to shut down the service using SNMP. The ACE supports traps and SNMP get requests but does not support set requests to configure values on the device. Please visit the below link for more information:
http://www.cisco.com/c/en/us/td/docs/interfaces_modules/services_modules/ace/vA5_1_0/configuration/administration/guide/admgd/snmp.html
Regards,
Kanwal
05-29-2014 02:13 PM
Rodrigo,
What is the version of the ACE that you have? and which model -- appliance or module?
Here is a list of things that you can do on an ACE 4710 or ACE 30 running A5(x.x) code:
http://www.cisco.com/c/en/us/td/docs/interfaces_modules/services_modules/ace/vA5_1_0/configuration/administration/guide/admgd/snmp.html#wp1034221
Let me know if you have any further questions.
-
Devendra Vishwakarma
**Please rate helpful posts**
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide