snmp on CE 2636 module

[johcox]

I'm using the CISCO-CONTENT-ENGINE-MIB to get mrtg stats from CE565s. I cannnot see anywhere that it should not also work on the 2636 CE modules as both run the same version of ACNS, but it does not seem to.

Anyone tried this successfully with the 2636 module?

-Julianne

[pradeepde]

The ACNS 5.x software implementation of SNMP supports the following MIBs:

MIB-II

ENTITY-MIB

HOST-RESOURCES-MIB

CISCO-CONTENT-ENGINE-MIB

CISCO-ENTITY-ASSET-MIB

CISCO-CONFIG-MAN-MIB

CISCO-CDP-MIB

Could you please refer the link below which has more details about the CISCO-CONTENT-ENGINE-MIB

http://www.cisco.com/en/US/products/sw/conntsw/ps491/products_configuration_guide_chapter09186a0080236630.html

[johcox]

So, you are saying that it should work for the 2636 modules as they are running ACNS? This was what I assumed too, but with the same snmp config that works successfully on the 565s, I can't get a response from the module.