Application Networking

I need a url match in a CSS (v7.20) content rule to distinguish between these two urls:/sieb_poc/finsobjmgr_enu/!1.b78/sieb_poc/finsobjmgr_enu/!2.b78The command url "/*!1." is not valid.It appears that a letter has to follow the *Is there another way...

Hi:We just experienced the following strange error just prior to reboot on our CSS-11800:FEB 9 05:35:14 6/2 161 IPV4-6: IPv4-SFM interface up: xx.xx.xx.xxx, circuit 1018Obviously, it appears that the second SFM in 6/2 had some kind of malfunction. ...

i have a 10 network lan behind a css 11503 i need to connect to another 10 network lan that sits behind another 11503. so basically it is 10 network-css-cloud-css-10 network. does anyone know if this is possible using gre or ipsec? how would i con...

With the <show load> command, I receive the information you can see in the attached file. While the relative load values make sense, I can't interpret the average response time and the Peak average response time. For instance, one can read :- Average...

I'm using the CISCO-CONTENT-ENGINE-MIB to get mrtg stats from CE565s. I cannnot see anywhere that it should not also work on the 2636 CE modules as both run the same version of ACNS, but it does not seem to.Anyone tried this successfully with the 26...

Hello I have a Cat 6509 as my core. MSFC. Dual Sup's L3. Default gateway is a PIX 515. I want to run a CE. Does it get placed in core? On outside interface of PIX? Do i do WCCP with 6509?

Hi One of our customers has the following:CSS 11150ap0502003ap10500099sCSS1 and CSS2 balance the load to a server farm on VLAN100 to the north of the CSSs. To the south is VLAN 200. CSS 3 is not yet connected. Server Farm----------VLAN100--...

When you configure this on a content rule and the idle timer expires, the CSS reclaims the flow. I am wondering if anyone knows whether the CSS issues a TCP RST in both directions (server and client) or if it just drops the session info from its tabl...

Does Webns support TACACS single-connection mode by default?

Hello.I have a SAN with an external client. The inbound backup flow goes through an 11506 with ver 7.2~. Backups of 2 to 3 hours work fine, but others with a longer time die around 8 - 10 hours into the session. I modified the flow-timeout multiplier...

CSM 4.1(2). I have application which use sticky. To take a real server to go gracefully down, the manual tells me to set the server in inserve standby, so all connections and sticky database can timeout. When I try to do that, there is no parameter "...

Hi,Is there a way with the CSS11501 to create the equivalent of a policy route ? E,g, If packets destination port is TCP 25 or UDP 23 and the packets are from VLAN x then forward the packets to address Y ? Can this be done with content rules and serv...