The interface inlineport 1/0/wan is in bypass mode

[JOHNSON CHIRRA]

Hi Team,

Recently we have configured the WAE device in my network, now today one major alram is showing on device and internet is very slow access.(Cisco 7541)

Unable acess to telnet or ssh , but i am able to ping and GUI access, but in central manager it showing registered

Inteface configuration

interface InlineGroup 1/0

inline vlan all

autosense

exit

regards

Johnson.

[Kanwaljeet Singh]

Hi Johnson,

What is the alarm you are getting?

Regards,

Kanwal

[JOHNSON CHIRRA]

Hi Sir,

Thank you for reply..

InlinePort are showing as bypass mode .All the users are facing internet access slowness issue

Model :OE7541

Ver: 5.0.3a

Major alarm

The interface Inlineport 1/0/wan is in Bypass

The interface Inlineport 1/0/lan is in Bypass

I have observed below Errors

Health probe for service 'fda' failed, ret code: 1.

Keepalive problem: Node Health Mgr incorrectly marked nodemgr dead, will reregisterCannot kill process with pid: 6361

Keepalive problem: Node Health Mgr incorrectly marked nodemgr dead, will reregisterHealth_probe for service 'stats_serializer' timed out.

Keepalive problem: Node Health Mgr incorrectly marked nodemgr dead, will reregisterCannot kill process with pid: 9431

Health_probe for service 'stats_collector' timed out.

Cannot kill process with pid: 9432

Health_probe for service 'nscd' timed out.

Cannot kill process with pid: 9430

Health_probe for service 'actastor_watchdog' timed out.

Cannot kill process with pid: 9425

Health_probe for service 'icaao' timed out.

Cannot kill process with pid: 9421

Health_probe for service 'httpao' timed out.

Cannot kill process with pid: 9422

Health_probe for service 'videoao' timed out.

Cannot kill process with pid: 9423

Health_probe for service 'nfsao' timed out.

Cannot kill process with pid: 9424

Health probe for service 'srserver' failed, ret code: 1.

Health_probe for service 'cifsao' timed out.

Cannot kill process with pid: 9426

Thanks & Regards

Johnson

[Kanwaljeet Singh]

Hi Johnson,

It could be a problem with inline card and i would suggest opening a TAC case to futher investigate. We have seen false alarm related to inline card going to bypass mode and can be ignored if you see optimization happening but it doesn't seem to be the case here since performance has been impacted here which is clear indication that optmization may not be happening.

Regards,

Kanwal