Urgent Help-Please Reply

[rania20052006]

Dear All,

I have here in my company 25 Cisco Switch 3560 .

as i know, i will configure the Switch with the Basic configuration like Hostname & IP-Address - & Gateway.

My 2 question is :-

1- if i configure the switch with the Basic Configuration like IP-Address & Subnet mask & So on , where its saved on the Switch Exactly ?

2- instead of have the 25 Switch in-front of me , and assign each switch his configuration like IP-Address & all the Things, is there any way to copy the Configurations from the switch which i configured on the Text file & then on each switch i will modify the Text file which include the configuration for that switch ( New configuration ) & then apply to that switch ( the New one ) ?

if i can do like that , can i & HOW CAN I DO IT , PLEASE HELP ME BY WRITING THE COMMAND WHICH I NEED TO FOLLOW IT ?

Thanks .

Rania.

[Gilles Dufour]

Rania,

you're on the wrong group for this question.

You should go to "Network Infrastructure" -> "Lan switchig..."

The config is saved in NVRAM.

You can't access the NVRAM directly.

You could have the config in a file and TFTP it to the router/switch

The command is

'copy tftp startup-config'

Regards,

Gilles.