06-03-2011 06:04 AM
I can find the timeouts for connection to the FWSM but not through the FWSM. I have an application timing out and I do NOT think it is the firewall causing it but I would like to know the default timeouts for session through the firewall.
Solved! Go to Solution.
06-03-2011 06:38 AM
Hi,
the default timeout for TCP connection is one hour as you can see from the command
FWSM(config)# timeout conn ?
configure mode commands/options:
0:0:0 | <0:5:0> - <1193:0:0> Idle time after which a TCP connection state
will be closed, default is 1:00:00
<0-0> Specify this value to never time out
Better would be to post this on the Firewalling forum though.
I hope this answers your question
Alessandro
--
If this helps you and/or answers your question please mark the question as "answered" and/or rate it, so other users can easily find it.
06-03-2011 06:38 AM
Hi,
the default timeout for TCP connection is one hour as you can see from the command
FWSM(config)# timeout conn ?
configure mode commands/options:
0:0:0 | <0:5:0> - <1193:0:0> Idle time after which a TCP connection state
will be closed, default is 1:00:00
<0-0> Specify this value to never time out
Better would be to post this on the Firewalling forum though.
I hope this answers your question
Alessandro
--
If this helps you and/or answers your question please mark the question as "answered" and/or rate it, so other users can easily find it.
06-03-2011 06:44 AM
Thank you Alessandro - I debated this forum versus the Firewalling forum and chose this one as it is for applications through the firewall.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide