Adding device to Device Group

[Brian Bergin]

I added an SG300-28PP to our LAN, updated the firmware.  FindIT sees it but when I try to add it to the Default Group in Device Group Management it doesn't want to stay.  I click on the Edit icon, choose it from the Devices drop down, it then adds to the table below, I click the Save icon and it disappears from the table.

Thoughts?

[David Harper]

Do you change the name of the device group by any chance?  I managed to reproduce this on one VM after changing the group name, but I can't seem to reproduce it reliably yet.

[David Harper]

Ok, I take it back.  There's no need to change the group name.  I can reproduce it without changing the name.

Not sure what is happening here, but so far, I can only reproduce the issue in the beta build - not in any of the later builds.  I think it might have been fixed already, which means you shouldn't see it in the next beta drop.  But I'll do some more checking to be certain.

Cheers,

Dave.

[Brian Bergin]

Ok.  Looking forward to the next drop.