12-03-2009 06:56 AM
Do the Cisco Blocker devices support SNMP monitoring?
We have a B10 Blocker that we are very pleased with (chose it over Barracuda after a head to head comparison) but the one feature it lacks for us is SNMP monitoring support. Well, that and the ability to do remote unattended shutdown from a UPS signal.
Am I missing something?
Solved! Go to Solution.
12-03-2009 08:00 AM
There is SNMP support on the blocker it is just disabled by default. If you look in the advance user guide that came on disk that came with the blocker it will show you the steps on enableing SNMP. Hope this helps!!!!
Brian
12-09-2009 09:40 AM
We also have MIB's you can use to import & monitor as well from products like Cacti.
If you want MIB's - contact me.
Jason
12-03-2009 08:00 AM
There is SNMP support on the blocker it is just disabled by default. If you look in the advance user guide that came on disk that came with the blocker it will show you the steps on enableing SNMP. Hope this helps!!!!
Brian
12-09-2009 09:40 AM
We also have MIB's you can use to import & monitor as well from products like Cacti.
If you want MIB's - contact me.
Jason
02-03-2010 08:33 PM
I would like the mibs please: info at snetworks.com
Just a note, we had SNMP running, and went I upgraded to 7 it disabled it again. A little concerning.
Bob James
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide