09-21-2011 04:58 PM
Any release why port 8080 would be open on the rv220W?
I ran an intensive scan with nmap on the rv220w earlier and it showed port 8080/tcp open along with 49150/tcp
i dont have these open by any rules. i think 49150 is upnp however.
09-22-2011 09:56 AM
Not sure why you see port 8080 open. I loaded your config but did not see it. You can also check for open port status from RV220W status tab.
For 49150, perhaps you might have some UPNP devices behind the lan that adverstize it? Since you do have UPnP discovery enable. Again check "View Open Port" for status.
09-22-2011 01:22 PM
Don, I think the 8080 port is from upnp via my qnap as this uses 8080 for it's admin panel. Though 8080 was shown on 172.16.10.1 (rv220w) my nas is the one with this port open.
Sent from Cisco Technical Support iPad App
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide