Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Simon, let's move this thread in the discussion forum so every one can see... Simon Slater says: Don, i'm running into an issue at work with the SSL Client.I get when installing the virtual passage client an error.:Cisco-SSLVPN-Tunnel Install Failed...
On behalf of Jo Kern wrote:"Dec 21, 2010RV220W -to- RV120W WDS linkI configured a WDS link between an RV120W and a RV220W.Worked just fine.Requirement would be to see immediately if the devices 'see' each other. If the WDS link is operational.Better ...
On behalf of Jo Kern wrote:Dec 21, 2010Upgraded from 1.0.0.8 to 1.0.0.27Upgraded the RV220.1.) Did a backup of the config file to my PC2.) Firmeware upgrade3.) Restored the config file back to the RV220Wall fineI see that the Picture of the device in...
Thanks Juan,Let's continue to monitor traffic while we're investigating in-house. If you happen to see it again, please also try to ping and collect the diagnostic files from ISA itself (devmgmt>CiscoServices>sendDiagnostic).Rgs,Don
Hi Juan,Thanks for reporting the issue. We're releasing 1.0.3 fw for quite sometime now and we haven't heard similar problem. Just a few questions:- did you fac-reset when upgrading the device? - you mentioned that "internet traffic stop", is it onl...
Thanks David+Ben for your comments + feedbacks. - Major changes were applied in 1.0.3 and thus required factory reset. Future fw upgrade won't require it.- Web filtering not effective with https. We're aware of this issue and currently working on for...
Simon,I understand your frustration. Me too! However there's good news. The team had found rootcause of this problem and working on the hot fix right now. You can revert back to 1.0.3.5 until further notice.Btw, not listing "Send to Local Server (DNA...
