Upgraded from 1.0.0.8 to 1.0.0.27

[ddiep]

On behalf of Jo Kern wrote:

Dec 21, 2010

Upgraded from 1.0.0.8 to 1.0.0.27

Upgraded the RV220.

1.) Did a backup of the config file to my PC

2.) Firmeware upgrade

3.) Restored the config file back to the RV220W

all fine

I see that the Picture of the device in the status display is updated from an RV120W picture to the proper RV220W picture. nice.

[linksysinfo]

Personally I never restore a backup to a newer firmware since there are normally new NVRAM variables added can overwrite older values or the old values have been removed.

since we are beta testing this device each installation of a new firmware i would recommend a factory default reset. and the setup the device manually.