bugsearch utility

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-28-2016 12:50 PM - edited 03-20-2019 09:07 PM
I'm curious as I've not used the bugsearch utility in some time. I was looking for issues in nx-os 6.2 for MDS 9000. I went for a status of Open and Support cases "has support case" left other filters blank. I found only 15 issues that to me were all somewhat obscure.
Does the bugsearch work well for this or am I being mislead?
- Labels:
-
Cisco Bugs

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-04-2016 12:01 PM
Bruce
https://bst.cloudapps.cisco.com/bugsearch/search Is this the site you used? If not, which one did you use?
Not entirely sure if I am understanding you. So, asking few questions, to get a better understanding.
Kind regards ... Palani
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-04-2016 12:04 PM
yes, that is the site.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-04-2016 12:38 PM
Ok, I see what you mean.
Sw defects may be platform independent OR dependent. When your search specifies the MDS9000 (hardware), the results tend to show the platform dependent bugs alone. Removing MDS9000 and keeping severity 5 or higher gave me little over 20 hits.
Few thoughts:
Please consider looking into "Open Caveats" of the Release Notes. Here, I have observed what are deemed as Severity 1 and Severity 2 bugs get listed. There is a similar section for "Resolved Caveats"
While doing bug search like you did, use the severity filter and choose 5 and higher. Severity 6 bugs are actually enhancement requests and so, usually not service impacting.
Please rate the usefulness of the bug notes critically. Folks usually pay attention and go about to improve its usefulness.
I hope this helps ... Palani
PS I am at loss to explain why the search did not reveal any Sev1 or Sev2 bugs in the search results.
