Bruce Kirkland
Beginner
Beginner
Member since ‎09-04-2011
‎08-18-2017

User Statistics

  • 24 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
5 Replies

User Activity

I'm preparing for a code upgrade to nx-os 6.2. On one switch I got disconnected while running a "show install all impact". The disconnect was a network problem, now that's fixed I try to run it again  show install all impact kickstart bootflash:m9500...
I'm curious as I've not used the bugsearch utility in some time. I was looking for issues in nx-os 6.2 for MDS 9000. I went for a status of Open and Support cases "has support case" left other filters blank.  I found only 15 issues that to me were al...
can I run fcip between 2 , mds9500  series switches that have different os levels, in particular 5.2 and 6.2 ?
I have Cisco MDS 9509 switches running nx-os 5.2(6a).  I'm behind on the supported version. I need to get to at least 5.2(8f) as of today 2015/08/11. The latest GA is 6.2(13) .  I'm thinking of some version of 6.2 as a target for the switches and DCN...
due to a migration I've been doing a lot of port debugging recently. Just curious it seems like something gets cleared when I do disable , enable from device manager that does not happen when I do a int, shut no shut - am I dreaming this? 
Community Statistics
Member Since ‎09-04-2011 08:58 PM
Date Last Visited ‎08-18-2017 04:00 AM
Posts 24