I am migrating configuration from my old cisco router 2811 IOS version "c2800nm-advsecurityk9-mz.124-15.XZ1.bin" to Cisco Router ISR-4351 IOS-XE version "isr4300-universalk9.16.03.07.SPA.bin".
My Old Router Configuration 2811 as follows:
bridge irb
!
!
interface Serial0/0/0
no ip address
encapsulation frame-relay IETF
no frame-relay inverse-arp
frame-relay lmi-type cisco
!
interface Serial0/0/0.1 point-to-point
snmp trap link-status
frame-relay interface-dlci 50
bridge-group 2------------> CLI NOT SUPPORT IOS-XE
bridge-group 2 spanning-disabled ----------> CLI NOT SUPPORT IOS-XE
!
interface Serial0/0/1
no ip address
encapsulation frame-relay IETF
frame-relay lmi-type cisco
!
interface Serial0/0/1.51 point-to-point
logging event subif-link-status
snmp trap link-status
frame-relay interface-dlci 51
bridge-group 3------------> CLI NOT SUPPORT IOS-XE
bridge-group 3 spanning-disabled---------> CLI NOT SUPPORT IOS-XE
!
interface BVI2
ip address 10.10.1.30 255.255.255.252
ip flow ingress
ip tcp adjust-mss 1436
!
interface BVI3
ip address 10.10.5.6 255.255.255.252
ip tcp adjust-mss 1436
bridge 2 protocol ieee------------> CLI NOT SUPPORT IOS-XE
bridge 2 route ip
bridge 3 protocol ieee------------> CLI NOT SUPPORT IOS-XE
bridge 3 route ip
How I can migrate configuration to my new router ISR-4351 as the above highlighted commands are not support on serial interface ?
