cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
112
Views
0
Helpful
0
Replies
Highlighted

Monitor loss counter command in CRS1000v

Hello,

I want to configure loss measurement(Y1731) in CSR1000v. according to its manual Class of Service(CoS)-level monitoring must be enabled on MEPs associated to the Ethernet frame loss operation by using the monitor loss counter command on the devices at both ends of the operation. but this command is not exist in (config-if-srv)# 
So after i configure single-ended loss measurement by ip sla command and check sending and receiving ccm and lmm and lmr frames, I see LMM and LMR counters are 0.

I will appreciate if someone help me.

Best regards,

0 REPLIES 0