Hi Everybody,
I have configured PPP multilink between r1 and r2 using one serial interface on each router. Everything is working fine except that interleaving seemed to be disabled in the output of the "show ppp multilink" command. I have included all the necessary show commands to help you help me figure out why interleaving is not working.
Note: To help you run through this quickly, I have highlighted some text with bold red color.
Thank you for any help.
r1#show ppp multilink
Multilink1
Bundle name: r2
Remote Username: r2
Remote Endpoint Discriminator: [1] r2
Local Username: r1
Local Endpoint Discriminator: [1] r1
Bundle up for 00:46:06, total bandwidth 128, load 1/255
Receive buffer limit 12000 bytes, frag timeout 1000 ms
Interleaving disabled
0/0 fragments/bytes in reassembly list
0 lost fragments, 0 reordered
0/0 discarded fragments/bytes, 0 lost received
0x99 received sequence, 0x119 sent sequence
Member links: 1 active, 0 inactive (max 255, min not set)
Se1/1, since 00:46:06, 160 weight, 152 frag size
No inactive multilink interfaces
===================================================
r1#
r1#show run interface multilink 1
Building configuration...
Current configuration : 289 bytes
!
interface Multilink1
ip address 10.0.0.1 255.255.255.0
ip tcp header-compression iphc-format
ppp authentication chap
ppp multilink
ppp multilink interleave
ppp multilink group 1
ppp multilink fragment delay 10
ppp multilink multiclass
ip rtp header-compression iphc-format
end
r1#
======================================================
r1#show run interface s1/1
Building configuration...
Current configuration : 118 bytes
!
interface Serial1/1
no ip address
encapsulation ppp
ppp multilink
ppp multilink group 1
clock rate 128000
end
====================================
r1#ping r2
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.0.0.2, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 16/16/20 ms
r1#
