Snmp configuration
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-26-2022 03:40 AM
Does Cisco sf200-24 and sf200-48 have snmp config in Gui??
- Labels:
-
Cisco Software
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-26-2022 04:18 AM
Try as SNMP -> Communities page and click Add
as per Emulator SF 250 shown below :
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-26-2022 05:50 AM
No I want exactly sf200 24 or sf200-48
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-26-2022 09:59 AM
check the admin guide, since i do not have a device in hand, what option do you see in your GUI?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-26-2022 10:14 AM
When I entered getting started in Gui under management I don't see enable snmp I only see enable http or enable https
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-26-2022 10:31 AM
what is the firmware you using, on the top right side you can go advanced mode
can you also post a screenshot for us to understand?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-26-2022 10:25 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-26-2022 10:27 PM
these photos show the firmware and tcp udp services
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-27-2022 05:23 AM
as per the below post the version you having does not support SNMP
https://community.cisco.com/t5/small-business-switches/snmp-on-sf-200-24p/td-p/2173468
If the option you need must, maybe try to upgrade to 1.3.2.2 latest firmware.
check the admin guide of 1.3
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-27-2022 06:18 AM
OK. one more question, does sf200-48 also doesn't have a snmp??
The one I showed you it's about sf200-24
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-27-2022 06:39 AM - edited 12-27-2022 06:39 AM
as per the document, the version of the firmware does not support it, maybe try to upgrade to the suggested firmware to 1.3 and test it.
SF200 are the same model, 24 and 48 are just port density, hope this gives clarity.
