I have uploaded a new image c1000-universalk9-mz.152-7.E10.bin
show flash:
I used the "boot system switch all flash:c1000-universalk9-mz.152-7.E10.bin" command to set the software on all members of the stack, but it did not set the variable with the new software on all units. So I did it manually:
boot system switch 1 flash:c1000-universalk9-mz.152-7.E10.bin
boot system switch 2 flash:c1000-universalk9-mz.152-7.E10.bin
boot system switch 3 flash:c1000-universalk9-mz.152-7.E10.bin
boot system switch 4 flash:c1000-universalk9-mz.152-7.E10.bin
You can see that only Active Member has updated.
Do you have any ideas why this happened? I also tried unplugging one unit from the power supply however that didn't help either. I also reset the stack members one by one, but also with no effect.
