cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1814
Views
0
Helpful
3
Replies
Highlighted
Beginner

Catalyst 9300 - complete reset to factory settings

Can anyone help me determine what files need to be deleted from flash to completely reset a Catalyst 9300-48U switch to factory defaults?

I'm looking to remove everything that has been added since the time it was pulled out of the box... config, vlans, switch number in stack, authentication mode new-style, etc...

I'm running version 16.6.2, so the "factory-reset all" command introduced in 16.8.x is not available on my switches.

Thank you.

Everyone's tags (2)
3 REPLIES 3
Beginner

Re: Catalyst 9300 - complete reset to factory settings

Have you had any luck with this?

 

I myself am trying to reset all the configurations to factory so I can start from scratch.

 

I'm at Everest 16.6.5 of my Catalyst 9300.

 

If anyone can help, I'd appreciate.

Beginner

Re: Catalyst 9300 - complete reset to factory settings

Hello,

 

You need to enter the following command at the Privilege exec mode:

 

 Device# factory-reset all

 

No system configuration is required to use the factory reset command but the command won't work in stacking mode. Also, using the "ALL" will erase all the content from the NVRAM, all the Cisco IOS images, including the current boot image, boot variables, startup and running configuration data, and user data.

 

You can use the option config to reset the start-up configurations or use the option boot-vars to reset the user added boot variables. Hope this helps !

Everyone's tags (2)

Re: Catalyst 9300 - complete reset to factory settings

I have tried the factory-reset all, and the switch still thinks a user ID & password is configured when I log into the WebGUI vs asking me to setup a password.    I am not sure what else to do.   Any suggestions?

 

Thx

Bryan

CreatePlease to create content