Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally. New Here? Click here to learn more and get started.
Hello Team, We are planning to deploy Cisco Firepower Management Center (vFMC) on VMware ESXi v9.x, and ESXi 9.x is mandatory in our environment due to internal standards. We would like guidance on compatibility, deployment steps, and any required co...
Modifying report in SQL from top section to append the value of 'SUB' to an account # but CUIC won't allow and throws an error... Any ideas? Created new report definition and added field and first SQL works as expected but when trying to append 'SUB'...
Anyone run into this? DCNM discovered my IOS-XE devices into an external fabric. But it thinks it can configure mask like /30 and a tag which is stupid.Does anyone know how to fix this? dcnm
Hello-. I am wondering if anyone could help solve a Telnet, SSH, and HTTPS connection problem between two remotely connected ASAs (firepower 1150), some intermediate devices to help connectivity between the two ASAs. Clearly Ping and Traceroute works...
Cat 9300L Reading another thread because I needed to wipe the switch. They recommended "Factory reset all" well now I have a switch with nothing butswitch:I've tried to restart to get to romon but nothing seems to affect itSystem Bootstrap, Version 1...
Dear Community Team,I hope this message finds you well.I have recently observed an influx of logs in our syslog server attributed to "Console user" and "unknown user." After thoroughly investigating, I could not locate these users in our network or c...
Hello PleaseI took a couple of courses last year on your platformI got some badges when I tried to transfer the transcript to my schoolIt was rejected because they do not have an ACE endorsementHow can these be fixed
I have 2 cisco 2811 2-FE routers, i configured fe0/1 on both routers with different ip addresses and did no shut.status is up but protocol is down. its like they are not aware of each other, speed and duplex is set to auto.when plugged into my laptop...
Can anyone help me determine what files need to be deleted from flash to completely reset a Catalyst 9300-48U switch to factory defaults? I'm looking to remove everything that has been added since the time it was pulled out of the box... config, vlan...