Hi there.
There are chapter Redundancy Package in Broadworks SIP Phone Interoperability Test Plan.
Test setup for Redundancy tests:
1) Make sure the DNS server is configured with the following DNS SRV records with
preferred order of addresses as follows, for the IOP1 Public Interoperability System.
Substitute iop2 for iop1 for the IOP2 Public Interoperability System:
− BroadWorks Application Server cluster FQDN: primary, secondary
Example:
_sip._udp.as.iop1.broadworks.net. IN SRV 1 50 5060
as1.iop1.broadworks.net.
_sip._udp.as.iop1.broadworks.net. IN SRV 2 50 5060
as2.iop1.broadworks.net.
− BroadWorks reverse Application Server cluster FQDN: secondary, primary
Example:
_sip._udp.revas.iop1.broadworks.net. IN SRV 1 50 5060
as2.iop1.broadworks.net.
_sip._udp.revas.iop1.broadworks.net. IN SRV 2 50 5060
as1.iop1.broadworks.net.
2) Set the SIP proxy address on the DUT to the BroadWorks Application Server cluster
FQDN.
3) Enable DNS SRV lookup on the DUT.
4) If failover times are configurable on the DUT, configure as follows.
− INVITE failover: Four to six seconds
− REGISTER failover: Under 30 seconds
− BYE failover: Four to six seconds
5) Using the primary BroadWorks Application Server CLI, configure the BroadWorks
CONTACT as the BroadWorks Application Server cluster FQDN.
Example:
AS_CLI/System/StartupParam> set bw.sip.accessclustercontacthost
as.iop1.broadworks.net
6) Using the secondary BroadWorks Application Server CLI, configure the BroadWorks
CONTACT as the BroadWorks Reverse Application Server cluster FQDN.
Example:
AS_CLI/System/StartupParam> set bw.sip.accessclustercontacthost
revas.iop1.broadworks.net
PUBLIC INTEROPERABILITY SYSTEM INSTRUCTIONS: CLI access is restricted. The Public
Interoperability System is preconfigured with CONTACT FQDNs. A preconfigured DNS server is
also available. For cluster and reverse cluster FQDNs and configure the DUT accordingly, see
section 4 Public Interoperability System Information.
So I have some questions.
1) Does Cisco Sandbox Broadworks have application server cluster.
2) If it has application server cluster could you please say it's FQDN (if available) or IP?
