cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
215
Views
0
Helpful
1
Replies

Documentation feedback - 9178 install guide

Raphael_L
Meraki Community All-Star
Meraki Community All-Star

Hi ,

https://documentation.meraki.com/Wireless/Install_and_Get_Started/Installation_Guides/CW9178I_Installation_Guide

There is a part refering to another SKU : Note: The CW9176I needs 802.3bt, class 6 (up to 60W) for full operation of AP. They can operate with 802.3at power but with a degraded operation. Please refer to the Power Source Options section in this document for further details.

Not sure if this is intended or not.

1 Reply 1

aleabrahao
Meraki Community All-Star
Meraki Community All-Star

 

Most likely the author copied text from the CW9176I guide and forgot to change the model number in that specific note.

https://documentation.meraki.com/Wireless/Install_and_Get_Started/Installation_Guides/CW9176I_Installation_Guide

In the Cisco Wireless 9178 Series Access Points Data Sheet, Cisco explicitly states that the CW9178I requires 802.3bt Class 6 (UPOE) to operate at full capability. Under 802.3at, the AP remains functional but is reduced to 2x2 operation and disables USB.

https://www.cisco.com/site/us/en/products/collateral/networking/wireless/access-points/wireless-9178-series-access-points-ds.html

I am not a Cisco employee. My suggestions are based on documentation of Cisco, best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.