Solved: ECMS Practice Question - Nov 18th

rmarta · ‎11-18-2020

ECMS Question

On the Meraki Dashboard, where should you navigate to make sure your MV cameras are in the correct time zone, and change it if you need to?

Cameras > Monitor > General
Cameras > Configure > General
Network-wide > Monitor > General
Network-wide > Configure > General

~~If you found this post helpful, please give it kudos. If my answer solved your problem, click "accept as solution" so that others can benefit from it.~~

The Meraki ECMS exam is now live! Test your knowledge of Meraki and become an official Cisco Meraki Solutions Specialist. More info on the ECMS exam found here.

For information regarding all of Meraki's training offerings, be sure to check out the Meraki Learning Hub.

rmarta · ‎11-23-2020

The correct answer is 4. Network-wide > Configure > General. That is the only option that is available for all types of networks, including Camera and combined ones as well. Option 2. Camera > Configure > General is not a valid option on combined networks.

I hope that helps!

~~If you found this post helpful, please give it kudos. If my answer solved your problem, click "accept as solution" so that others can benefit from it.~~

The Meraki ECMS exam is now live! Test your knowledge of Meraki and become an official Cisco Meraki Solutions Specialist. More info on the ECMS exam found here.

For information regarding all of Meraki's training offerings, be sure to check out the Meraki Learning Hub.

View solution in original post

Raphael_L · ‎11-18-2020

Might have 2 answers here ;

Spoiler

Cameras > Configure > General redirects to Network-wide > Configure > General. So 2 and 4 could be correct.

CMR · ‎11-18-2020

Beware the golf ball

If my answer solves your problem please click Accept as Solution so others can benefit from it.

rmarta · ‎11-23-2020

The correct answer is 4. Network-wide > Configure > General. That is the only option that is available for all types of networks, including Camera and combined ones as well. Option 2. Camera > Configure > General is not a valid option on combined networks.

I hope that helps!

~~If you found this post helpful, please give it kudos. If my answer solved your problem, click "accept as solution" so that others can benefit from it.~~

The Meraki ECMS exam is now live! Test your knowledge of Meraki and become an official Cisco Meraki Solutions Specialist. More info on the ECMS exam found here.

For information regarding all of Meraki's training offerings, be sure to check out the Meraki Learning Hub.