Solved: Re: Firmware Upgrades

Joshua T · ‎02-03-2023

Is there a way to all appliances in our stack to auto-upgrade the firmware?

aleabrahao · ‎02-03-2023

You can schedule it:

https://documentation.meraki.com/General_Administration/Firmware_Upgrades/Managing_Firmware_Upgrades

I am not a Cisco employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

View solution in original post

aleabrahao · ‎02-03-2023

You can schedule it:

https://documentation.meraki.com/General_Administration/Firmware_Upgrades/Managing_Firmware_Upgrades

I am not a Cisco employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

CMR · ‎02-03-2023

@Joshua T if you mean apply updates without having to schedule it, then the only option to get more frequent updates is to tick the try beta firmware in Network-wide Configure / General as below, otherwise you should get updates a few times a year:

If my answer solves your problem please click Accept as Solution so others can benefit from it.

Joshua T · ‎02-06-2023

Thank you, to everyone who suggested a fix.

Kave · ‎04-03-2023

HTTPS Issue has ben solved on L3 Switch and MX -firmware issu on 17 x Ver or higher

We are using MX105 and MS 250.

had issue with firmware upgrade when upgrade from 16 x to 17 x or higher ver.

problem was HTTPS traffic got slow even with good bandwidth .

Please use Unique Client Identifier instead MAC addres as shown on screen shot.

you can find it in Security & SD-WAN --> Addressing&VLANs

kav noroozi