12-23-2019 07:22 AM
Hello,
I have a question. Can I implement a NAC with ISE without configure 802.1x ?.
It's ISE agentless or anyconnect is mandatory?
Thanks.
Solved! Go to Solution.
12-23-2019 12:56 PM
Ok well any solution will be a compromise if you need to support multiple vendors. You can create authorization rules in ISE based on the type of switch the user/computer is connecting from and return the syntax of the ACL specific to that manufacturer to be applied to the user session.
Yes, I believe you should be able to apply monitor mode on all 3 manufacturer switches. You should confirm this is HP/Aruba and Juniper forums, as this forum specialises in Cisco solutions.
HTH
12-23-2019 07:28 AM
12-23-2019 12:30 PM
Hello RJI,
I need a NAC solution that works with Cisco, Aruba and Juniper (switches, APs, Routers).
I want implement Monitor Mode/Low-Impact Mode those devices?
Thanks.
12-23-2019 12:56 PM
Ok well any solution will be a compromise if you need to support multiple vendors. You can create authorization rules in ISE based on the type of switch the user/computer is connecting from and return the syntax of the ACL specific to that manufacturer to be applied to the user session.
Yes, I believe you should be able to apply monitor mode on all 3 manufacturer switches. You should confirm this is HP/Aruba and Juniper forums, as this forum specialises in Cisco solutions.
HTH
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: