12-23-2019 07:22 AM
Hello,
I have a question. Can I implement a NAC with ISE without configure 802.1x ?.
It's ISE agentless or anyconnect is mandatory?
Thanks.
Solved! Go to Solution.
12-23-2019 12:56 PM
Ok well any solution will be a compromise if you need to support multiple vendors. You can create authorization rules in ISE based on the type of switch the user/computer is connecting from and return the syntax of the ACL specific to that manufacturer to be applied to the user session.
Yes, I believe you should be able to apply monitor mode on all 3 manufacturer switches. You should confirm this is HP/Aruba and Juniper forums, as this forum specialises in Cisco solutions.
HTH
12-23-2019 07:28 AM
12-23-2019 12:30 PM
Hello RJI,
I need a NAC solution that works with Cisco, Aruba and Juniper (switches, APs, Routers).
I want implement Monitor Mode/Low-Impact Mode those devices?
Thanks.
12-23-2019 12:56 PM
Ok well any solution will be a compromise if you need to support multiple vendors. You can create authorization rules in ISE based on the type of switch the user/computer is connecting from and return the syntax of the ACL specific to that manufacturer to be applied to the user session.
Yes, I believe you should be able to apply monitor mode on all 3 manufacturer switches. You should confirm this is HP/Aruba and Juniper forums, as this forum specialises in Cisco solutions.
HTH
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide