Enabling VPN NAT on a VLAN using the API

[tvreeland]

I am using the API to automatically clone new networks from a default network. I am trying to setup the site to site vpn for each new network but I am not able to figure out how to enable `VPN on with translation` on the new networks. Am I missing it somewhere in the API documentation or is there not an ability to enable this setting using the API?

Kind Regards,

[Alexander Stevenson]

Hi @tvreeland,

If this is a Meraki API, you could also post this on the Meraki Community:

https://community.meraki.com/t5/Meraki-Community/ct-p/meraki