Getting WinSCP on n9k to work - Settings/Config required

[Jason Leschnik]

WinSCP configuration required for Nexus 9000

feature scp
feature bash

 

Configuration required in WinSCP

Note: We can also just use "run bash" without the "sudo su" part, this has been lab tested too and appears to work as expected.

After these configuration changes are made you can click "ok" then proceed to connecting to the device as per usual. 

HTH
Regards,
Jason.

[robertdecsi]

Huge thanks Jason !

[jacob_zhu]

Thank you, Just I need

[krozier]

The steps worked perfectly. Thanks!

[jm583q]

cannot make it work for Cisco 9k series XE, for XR is working fine

[Mike Sandvik]

I am curious if this method will work on MDS switches as well

[kalbritt]

Great work!  I also had to use feature scp and feature bash.