This content pack contains a Cisco Orchestrator automation pack that contains services that enable the use of the OpSource Cloud ( http://www.opsource.net/Services/Public-Cloud ). There are also several services that replace Multi-Cloud Accelerator services to enable the use of the content.
This content is a good example of the ease of extension of the Multi-Cloud content to other 3rd party cloud providers.
This content was created as part of a proof of concept with a service provider and is therefore incomplete and instructions for use do not exist so investigation of the content and some trial and error is required to utilize.
Note that the Cloud Portal services provided by the Multi-Cloud Accelerator content do not always work with this content. Configuration of Cisco IAC and Multi-Cloud for use with this content is a manual process of manipulating some service items.
Multi-Cloud Solution Accelerator Kit v1.3
71093-OpSource Public Cloud - MultiCloud Add-on.zip
The first link says 9200s support PVLANs, the second link doesn't list a maximum. Does the 9200 series support PVLANs and does it match the 16/20 (primary/secondary) that a 9300 supports? Does the 9200 support PVLAN over VXLAN?https://www.cisco....
Hello.I never run Nexus Swithes...So, I have a few questions. In an environment configured with a VPC Can the traffic of the Orphan port connected to the bottom be forwarded through the peer link??? (I wonder if it works like Catalyst's Inter-link.) ...
hello, i tried to find a document describing it but was not successful. i understood that on an ACI witch a BD and one EPG is always consuming an internal VLAN. maximum numbr of vlans is 3964 (or similar). therfore you can approx copnfigure 1980 EPGs...
Hi, For a UCS customer can I use 93360 and provide both IP and SAN networking in a converged infrastructure deploymentBasically UCS+FI is connecting to 93360 (instead of 93180+MDS) for internet and SAN array Thanks & Regards,Sreeram