I'm trying to build a topology from scratch without using one of the default choices, but can't seem to figure out how to add a NX-OSv 9000 device. I see it referenced throughout the lab, but the only NX-OSv device I see appears to be based on a Nexus 7000 image. I'm trying to build the topology from the UWM web interface, My simulations > Launch new simulation > Editor button. The only device options I see are in the image below.
![Screen Shot 2019-07-02 at 4.30.13 PM.png Screen Shot 2019-07-02 at 4.30.13 PM.png](https://community.cisco.com/t5/image/serverpage/image-id/39966iAA94D95F63BF4CEA/image-size/large?v=v2&px=999)
Thanks in advance,
Rich