Discussões Geral

Interaja com especialistas para solucionar seus problemas. Publique sua pergunta para obter ajuda.
cancelar
Mostrar resultados para 
Pesquisar em vez de 
Queria dizer: 
cancel
Bem-vindo à Comunidade!
A Comunidade é um hub para se conectar com seus colegas e especialistas da Cisco para pedir ajuda, compartilhar sua experiência, construir sua rede e crescer profissionalmente.
Novo aqui? Clique aqui para aprender mais e começar.

Posts de fórum

Hello guys.  This is not the first timeI have seen the kind of impasse when uploading an image via ROMMON. I followed a community procedure where the first step was the command Erase Disk0: where we deleted all files contained in Flash, but when tryi...

Screenshot_2.png

Bom dia para todos   No RV320 configurei corretamente WAN1e WAN2. Configurei tmb no "Bandwidth Management" as velocidades, todavia o Speedtest retorna somente a velocidade da WAN1 e não das duas acoplada. Tem alguma indicação adicional ? Grato Maquis...

Maquis1964 por Level 1
  • 1245 Apresentações
  • 2 respostas
  • 0 Útil

I've recently onboarded on the CSAPI for customer information in order to get inventory information, I got the token and everything set up although I only get the below answer when I perform a get request to the url: https://apx.cisco.com/cs/api/v1/c...

anluarsa11 por Level 1
  • 1180 Apresentações
  • 1 respostas
  • 0 Útil

  Hi, I have Cisco 1921/K9 behind operator’s router. And I want to pass multicast traffic – IPTV - from WAN port to a VLAN. At the bottom is a resumed router configuration. When I execute sh ip igmp snooping mrouter there is no port at the vlan! I’m ...

Boa tarde, Estou tendo o seguinte problema, quando eu realizo uma chamada externa através do meu ramal sip para um número pstn, ele demora dez segundos para começar a chamar. Sei que pode ser algo com o DIalPlan, mas tentei algumas configurações e nã...

rafahss por Level 1
  • 987 Apresentações
  • 0 respostas
  • 0 Útil
Tópicos não respondidos