AMP for Endpoint Within Policy/Compliance?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-31-2018 08:21 AM - edited 02-20-2020 09:06 PM
Is it possible to get a consolidated view of devices within a specific group that don't have the most recent policy applied? I have a bunch of Linux connectors that are older due to compatibility with OS versioning. When I view them within "Computers" area I get "Information Not Available" because its not connector 1.7.0.545 or newer. I have to go into "Events" to see that the device has had a recent policy applied.
I would have thought validating that all your connectors are up to date with definitions would be a pretty obvious functionality but I can't seem to see an easy way to view this with older connectors.
Thanks
- Labels:
-
AMP for Endpoints
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-16-2018 09:26 PM
Have you tried: Management > Computers > Expand the filters > Use the desired filters. One of the filters is "Definition Last Updated"
I hope this helps!
Thank you for rating helpful posts!
