Display file scan result to user

[llomjaria]

Hello,

When user right clicks on file, chooses Cisco Secure Endpoint -> Scan now. The result of the scan is not showed to user. Is there a way to display scan result ?

[Roman Valenta · Accepted solution]

Yes, the results are now located in Event History. Hope this picture will help.

 

Regards,

Roman 

[llomjaria]

Thank you for the response!

I have found it but it is not a simple way for an average user to check file scan result. Maybe there is a way to show popup windows with results..

[Ken Stieers · Accepted solution]

Its in the eventlog.

When they went to the new/Anyconnect gui they left some important stuff out...

[Roman Valenta]

Good news, and just to close this loop as I just learned. This should be resolved and new addition will be implemented most likely in the next release 8.1.7 This was something that our Engineering Team worked on based on the feedback from our Customers and TAC.

-Roman

[Ken Stieers]

Thanks Roman!!