Hi All,
I have a quick question regarding configuring active/passive failover.
Lets say I have 2 5510's.
I plan on using;
1 interface for lan failover(LANFAIL)
1 interface for statefull failover (STATEFULLFAIL)
I already have a bunch of other interfaces(physical/logical) configured
outside
dmz
and subinterfaces on my inside networks, i.e
e0/1.2
e0/1.3
e0/1.4
.
.
.
etc
Now I seem to be reading conflicting documentation regarding what configuration I need to configure BEFORE I run the highscalability wizard.
Do I just need to configure a single IP on my secondary firewall say on e0/1.2 on the same lan as e0/1.2 on my primary and ensure that my laptop can reach it for ASDM?
OR do I have to configure a "secondary IP" for each interface configured on the primary? or is this only neccessary for those interfaces I wish to "manage" the secondary firewall through? The reason I ask is because I have a lot of subnets configured.
Also do I need to configure IP addressing on my lan failover and statefull failover interfaces? or is that just done as part of the high scalability wizard?
Many thanks.