SSL Connectivity Configuration

[gputhota]

Hi,

I installed the SSL Certificates on the windows machine where our CPO server is configured. And I also configured the web service adapter to use secured authentication on the default port.

Is there anything else I would need to configure other than the above inorder to have the SSL connectivity? Also are there any standard tests I can perform from CPO inorder to validate this configuration.

Thanks,
Greg

[Shaun Roberts · Accepted solution]

You need to make sure you have followed all the steps on page 12 of the Northbound Web Services guide. If you have you can test by opening a browser and going to https:// teo server>:/WS/Process?WSDL

You can test with portal feeding information in or you can run web service executes (in CPO) against it to further test.

[gputhota]

Thanks Chris.

I installed the certificates as mentioned in the guide. Along with that, I had to edit the binding settings seperately for CPO webconsole and CPO Monitoring under IIS. Now the CPO webconsole  can also be accessed using https in our environment.

Regards,
Greg

[gputhota]

One final question about this:

If I have the CPO webconsole installed on a different host than the CPO server, is there a need to install seperate certificate on the host where CPO webconsole is present?

Regards,
Greg