10-22-2001 11:17 PM - edited 02-21-2020 09:57 AM
I configured IAS(RADIUS) on IIS4.0(option pack) & cisco AS2511RJ as NAS.I put radius only as the authentication method & every thing works perfectly except AAA accounting.AAA accounting does not create any logs on the NTserver.(I checked all the basic checks).
Also I am not sure about the entries on the vsa info.(vendor specific attribute).[note that I am using IIS4.0].
Pls help.
exmrr.
10-29-2001 03:42 PM
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Thank you for posting.
10-29-2001 03:46 PM
Just turning radius on in the cisco does not turn accounting on, or authorisation on. So you need to make sure that the NAS config is built on "AAA new- model", and has the line "AAA accounting network start-stop radius". Please check the format of that last command, I'm re-calling from memory (eek).
11-05-2001 11:40 AM
I have the same problem using tacacs+ on my 2511. Authentication ok, but no accounting log. aaa acccounting is enabled. If you find a solution please post or email me at eymatsud@health.state.hi.us
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide