acs appliance with flapping ethernet interface

[t.waibel]

Hello,

we have an acs appliance with software 4.0. Since a couple of weeks the ethernet interface of the appliance starts to flap every minute. Neither changing the switchport nor the cable or the switch was not succesful.

Does anybody know a bug ?

Best regards

Torsten Waibel

[Ganesh Hariharan]

Hello,
we
have an acs appliance with software 4.0. Since a couple of weeks the
ethernet interface of the appliance starts to flap every minute.
Neither changing the switchport nor the cable or the switch was not
succesful.
Does anybody know a bug ?
Best regards
Torsten Waibel

Hi Torsten,

Just try to configure a command via console toggle nic in ACS appliance and then check it happen or not.

HTH

If helpful do rate

Ganesh.H

[t.waibel]

Hi Ganesh,

sorry the command is not known by the windows acs appliance.

acs2>  toggle nic
toggle nic: command not found.

Our hardware suppliers doesn't found any bug together with cisco.

Finally we will change the hardware.

Best regards

Torsten